Toilet Paper Holder Bridge Instruction

The bridge-style toilet paper holder combines wooden design with metal brackets for a modern and sturdy bathroom accessory. Follow these steps for secure installation.

Step 1: Position the Holder

1. Hold the toilet paper holder against the wall at your desired height.

2. Use a spirit level to make sure it is perfectly straight.

3. Lightly draw a guideline with a pencil where the brackets should be mounted.

Step 2: Mark the Drill Points

1. Place the metal brackets on the guideline.

2. Mark the drill hole positions through the bracket slots.

Step 3: Drill Holes & Insert Wall Plugs

1. Drill holes at the pencil marks.

2. Depending on wall type:

   • Concrete or brick walls → use heavy-duty plugs.

   • Drywall/gypsum board → use drywall anchors.

   • Wooden walls → screw directly without plugs.

3. Insert the wall plugs into the drilled holes until flush.

Step 4: Secure the Metal Brackets

1. Place the metal brackets over the wall plugs.

2. Insert screws through the brackets and tighten until firmly fixed.

Step 5: Attach the Wooden Bridge Piece

1. Push the wooden part of the holder into the mounted brackets.

2. Secure it in place by tightening the small screws provided.

3. Check that the wooden bridge is stable and straight.

Final Checks

• Test by placing a toilet paper roll into the holder.

• Tighten screws if there is any movement.

• Wipe off pencil guidelines for a clean finish.